2. Register the media.

Procedure
  1. Tap AP-640_Panel_Icon_SETUP Setup.
  2. Select New.
  3. Tap Next.

    Printed heaters
  4. Enter a new media name and tap OK.

    Tap the keyboard displayed on the screen to enter the name.

    You can use up to 15 alphanumeric characters.

    AP-640_Panel_Setup_Newmedia_ImputName
  5. Check the name you have entered and tap Next if it is correct.
    To make corrections, tap the name you entered.
  6. On the Select Sheet Type screen, select Opaque/Transparent and tap Next.
  7. The Sheet Settings screen appears. Configure the settings as shown below depending on the sheet type.
    • For opaque media
      1. Tap Side Margin to set the margin.

        You can select 5 mm (0.2 in.), 10 mm (0.39 in.), or 25 mm (0.98 in.).

      2. Tap OK.
    • For transparent media, etc.
      • Sheet Width setting
        1. Tap Add a favorite to the right of Sheet Width.
        2. Enter the sheet width and tap OK.
      • Sheet Right Edge setting
        1. Tap Change to the right of Sheet Right Edge.
        2. Tap AP-640_Panel_Icon_LEFT or AP-640_Panel_Icon_RIGHT to move the sub carriage's base point mark to the right edge of the media, and then tap OK.
      • Side Margin setting
        1. Tap Side Margin to set the margin.

          You can select 5 mm (0.2 in.), 10 mm (0.39 in.), or 25 mm (0.98 in.).

        2. Tap OK.
  8. Tap Next.
  9. On the Setup Method screen, select Do Not Use Take-up Unit and tap Start Setup.