1. B: Determine the positions of the media (transparent media, etc.).

Use the following procedure to determine the positions of the media when using transparent media and media with high reflectance, whose edges cannot be detected.

Procedure
  1. Tap the operation panel.

    ON
  2. When instructions appear on the screen, tap AP-640_Panel_Icon_ONOFF on the operation panel.
    The power to the operation panel is switched on.
  3. Set the Skewing Correction Support at Setup.
    1. Tap AP-640_Panel_Icon_MENU.
    2. Tap Preferences - Skewing Correction Support at Setup.
    3. Select Disable and tap Save.
    4. Press AP-640_Panel_Icon_HOME to return to the original screen.
  4. Open the front cover.
  5. Move the media clamps to the outside of the grit rollers on the left and right edges respectively.

    ER-642_Media-clamp
  6. Move to the rear of the printer. Release the locking mechanisms of the media holders, and then draw them to the left and right ends respectively.
    Unfasten the media holder
  7. Pass the leading edge of the media between the pinch rollers () and the grit rollers ().

    Feed cut media from the back of the printer
  8. Lower the loading lever (rear).
    The media is held in place.

    Lower the loading lever (rear)
  9. (Move to the front of the printer.) Gently hold down the media and raise the loading lever (front).

    Raise the loading lever at the front
  10. If an auxiliary drying unit (DU3) is installed, insert the leading edge of the media into the dryer.
  11. Make sure the right edge of the media is in line with the guide line (A).

    Go to the front of the printer and make sure you are following the guidelines
  12. Lower the loading lever (front).
    The media is held in place.

    Lower the low binding (front side)
  13. Line up the edges of the media with the centers of the holes of the left and right media clamps.

    Ins_Roll_MediaToHolder8
    IMPORTANT

    Be sure to use the media clamps when you set up media.

    If you load the media clamps directly before printing after the media setup is complete, the machine may print on the media clamps.

  14. Close the front cover.