1. A: Determine the positions of the media (opaque media).

This section describes how to use the suction fan to prevent media skewing.

Procedure
  1. Tap the operation panel.

    ON
  2. When instructions appear on the screen, tap AP-640_Panel_Icon_ONOFF on the operation panel.
    The power to the operation panel is switched on.
  3. Set the Skewing Correction Support at Setup.
    1. Tap AP-640_Panel_Icon_MENU.
    2. Tap Preferences - Skewing Correction Support at Setup.
    3. Select Enable and tap Save.
    4. Press AP-640_Panel_Icon_HOME to return to the original screen.
  4. Open the front cover.
  5. Move the media clamps to the outside of the grit rollers on the left and right edges respectively.

    ER-642_Media-clamp
  6. Move to the rear of the printer. Release the locking mechanisms of the media holders, and then draw them to the left and right ends respectively.
    Unfasten the media holder
  7. From the rear of the printer, pass the leading edge of the media between the pinch rollers () and the grit rollers ().

    You will hear a beep. Approximately 5 seconds later, you will hear two beeps, and then the suction fan will activate. While this fan is operating, the media will not move backward even if you remove your hands from it.

    When loading the media from the front of the printer, feed the leading edge of the media (the side where printing will start) over the platen, and then pull the media to the front to activate the suction fan.


    Feed cut media from the back of the printer
  8. Make sure the right edge of the media is in line with the guide line (A).

    Go to the front of the printer and make sure you are following the guidelines
  9. Lower the loading lever (front).
    The media is held in place.

    Lower the low binding (front side)
  10. Line up the edges of the media with the centers of the holes of the left and right media clamps.

    Ins_Roll_MediaToHolder8
    IMPORTANT

    Be sure to use the media clamps when you set up media.

    If you load the media clamps directly before printing after the media setup is complete, the machine may print on the media clamps.

  11. Close the front cover.