2. Installing the Cleaning Liquid and Selecting the Ink Type

Procedure
  1. Set the cleaning cartridge in the cleaning liquid slot.
    Orient the cartridge so its protrusion () is face up, and then, while keeping the cartridge level, insert the cartridge as far as it will go.
    CleaningCartridge_Install
  2. Ink Type Not Set screen will appear. Tap TR3 CMYK.

    This is set to TR3 CMYK by default. When using this ink type, tap OK and proceed to Step 4.

  3. Select the ink type to use, and then tap OK.
  4. Tap Execute.
    MEMO

    If an error occurs when the machine is filled with ink the second time or later, if the sub power is turned off to stop work, and in similar situations, the message Discard the discharged fluid in the bottle. will appear on the operation panel.

    When this message appears, remove the drain bottle and discard the discharged fluid.

    When the message Discard the discharged fluid in the bottle. appears on the operation panel
    1. Remove the drain bottle and discard the discharged fluid.

      BLU_USE_3-WasteLiquid-6
      CAUTION

      Before you detach the drain bottle, be sure to wait for the screen to display Discard the discharged fluid in the bottle.. After discarding the discharged fluid, promptly attach the drain bottle to the machine.

      Failing to follow this procedure may cause discharged fluid to flow out of the tube and spill, soiling your hands or the floor.

      IMPORTANT

      When you remove the drain bottle, a few drops of discharged fluid may come out of the machine. Exercise caution to prevent this fluid from soiling your hands or the floor.

    2. Quickly attach the emptied drain bottle to the machine once more.
    3. Tap Finish.
      The Manual Cleaning during Ink Filling screen appears.