Changing the Ratio of the Image Width to Height

Change the ratio of the width to height of the print data.

When you open Settings, this setting is set to on. You can change the size while maintaining the ratio of the width to height even if you perform Scaling or change the width or height value. If you change this setting, you can change just the width or just the height by itself. For example, if the width of the print data is slightly lacking in relation to the printing area, you can lengthen the print data in the width direction.

Note that you cannot configure this setting with Queue Properties. Configure it on the job.

Procedure
  1. Use one of the methods below to open the Settings window.
    • Double-click the job to set.
    • Right-click the job to set, and then click Edit Design - Settings.
    • With a job selected, click VW7_JobMenu1 on the left side of the job tool area, and then click VW7_Customize Settings.
  2. Click VW7_Layout Layout.
  3. Click VW7_ICON_AspectToUnlock under Scaling.
    The icon changes to VW7_ICON_AspectToLock.
  4. Change the value or Scale.
    The changes are reflected in the preview area of the Settings.
    MEMO After you change the width or height ratio, you can use one of the methods below to return it to its original state.
    • Reset ALL

      Returns to the original ratio and size.

    • Restore Original Ratio

      The window for selecting the reference appears, so select Width or Height.

  5. Click OK.
    The changes will be applied, and you will be returned to the main window.