Maintaining the Clipped Position

Print a clipped image while maintaining its original position. You can reprint only the necessary part of the same print data.

As an example, this explains printing to multiple objects to be printed on using a flat table model.
  1. Place the jig (A) on the flat table, and position eight objects to be printed on.
  2. Create print data (B) for the jig size, and perform printing.
    CrippedPositionDescription1
  3. Because a problem (C) occurred during printing, position an object to be printed on only in that position (D) and perform reprinting (E).
CrippedPositionDescription2

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Use one of the methods below to open the Job Settings window.
    • Double-click the job to set.
    • Right-click on the job to set, then click Edit Design - Job Settings .
    • With a job selected, click VW7_JobMenu1 on the left side of the job tool area, and then click VW7_CustomizeJob Settings .
  2. Click VW7_CripandTile Clip and Tile.
  3. Select the Clip Image checkbox under Clipping.
  4. Part for reprinting: Set the clip area (A).
    Either drag the red points in the layout area or use Top Left Position and Size under Clipping and set the clip area.
    VW7_mike1
  5. Select the Maintain Clipped Position checkbox.
    You can print a clipped image maintained at its original position.
    IMPORTANT If this setting is not made, the clipped image will automatically be placed in the origin position.
    VW7_mike2
    MEMO Maintain Clipped Position cannot be set in the following situations:
    • Tiling has been set.
    • There are multiple pages.
    • Nested job
    • Multiple copies are printed.
  6. Click OK.
    You are returned to the main window.