Adding Trim Marks or Margin Marks

Add trim marks, margin marks, or special cut marks around the image, then print.
Type Details
Trim Marks
Prints trim marks added at the four corners of the job as shown in the diagram.
Margin Marks

Leaves margins around the job and prints the margin marks at the four corners of the margin as shown in the diagram.

Set the horizontal margin with Horizontal (1) and the vertical margin with Vertical (2) for the job.
FOTOBA Cutline Marks

Adds and prints specialized cutting marks when using Fotoba International S.R.L.'s finishing cutters.

To print lines in the vertical direction, select the Print vertical lines check box.

MEMO You can set Crop Marks (Print&Cut Alignment) regardless of whether margin marks or trim marks are present. However, this cannot be set on printers that do not support the cutting function.
Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Select the mark to be added from Type under Marks.
    • Trim Marks
    • Margin Marks
    • FOTOBA Cutline Marks
  4. Click OK.
  5. Add the job to the job list, and then start printing.
    The selected marks are printed around the image.