Step 1: Perform Test Cutting

Procedure
  1. Click Printer - Test Cut on the menu bar.
    The following message appears: The following cutting will be performed. Do you want to continue?

    Test cutting will be performed under the displayed conditions. Check the page size and media type.

  2. Click OK.
    The job for test cutting is added to the job list (Queue A folder), and the test pattern is cut automatically.

    Once the job has been cut, it is automatically deleted from the job list.

  3. Check the results of the cutting test.
    It is necessary to adjust the settings for each item according to the test results.

    LG-TestcutPattern
    Check item Result Setting item Adjustment
    Check the shape. The cut shape is distorted. Cutting Speed Reduce
    Peel off the circle. The square also peels off. Cutting Force Increase
    Some uncut areas remain. Cutting Speed Reduce
    Peel off the square. The blade leaves faint traces on the backing paper. Cutting Force No change
    The blade trace is indistinct. Increase
    The blade trace is too deep and cuts into the backing paper. Reduce
    Check the shape of the square you have peeled off. testcut_A The corners are not rounded and do not have "horns." Blade Offset No change
    testcut_B The corners are rounded. Increase
    testcut_C The corners have "horns." Reduce