Output - Printing Output

Procedure
  1. Correctly load in the machine the media or the object and prepare to print.

    For details on how to load media or the various adjustments made before printing, refer to the documentation for the machine you are using.

  2. Click tb_standard_send-to-device.

    The Send to Device dialog box appears.

  3. Select the machine where the data will be sent.

    If the machine you are using is not displayed, it has not been set in VersaWorks.

    For details on how to set the machine to output to, see the "VersaWorks Installation Guide."

    prac_pc_output_j
  4. In Output, select either Page or Objects.
    MEMO

    Select Page to output at the Standard Page Sizes designated with Design Central. Select Objects to output at the size of the object.

    You can check the Output of Page and Objects with Preview.

  5. Click Print Parameters to configure the output settings.
    Configure the following settings with Cutting Options on the Cut Controls tab.
    • Operation Mode: Print Only
    • Select the Crop mark (Printing) check box.
    Parameter1

    The Quality, Cut Controls, and Others tabs are located in Print Parameters. These tabs set operations during printing and cutting. For more information, refer to Print Parameters.

  6. Click OK.
    The Print Parameters window closes.
  7. Click Send.

    After processing by the RIP, the data is sent and then printing starts.

    MEMO

    You can check the progress of the printing in the display on the machine, in Utility, or by other means.

    For details, refer to the user's manual for the model that you are using.

    When printing is finished, remove the media and perform lamination.