3. Select the media.

Procedure
  1. Tap Panel_Icon_UnSetupSetup.
    The registered media is displayed in a list.
    VG4-640_panel_select_media
  2. Select the media to use.
    MEMO You can search for media in the media list by keyword and register media as favorites. The media list can also be set to show only media registered as favorites. Keyword searching and favorites registration can be used at the same time.
    • Searching for keywords in the media list
      1. Tap Panel_Icon_Edit.
      2. Enter the media to search for.

        Searching for partial matches instead of exact matches is also possible.

        Medianame_Panel
      3. Tap OK.

        Media filtered according to the keywords will be displayed.

      4. Select the media to use from the search results.
    • Registering media to favorites and showing only media registered as favorites

      Tap Panel_Icon_FavoriteDisplay for the media to register it to favorites.

      The icon for the favorited media will be displayed as Panel_Icon_BookmarkedAsFavorite.

      To show only media registered as favorites, tap the icon indicated below.

      Favorite_Panel

    To reset the keyword search or favorites registration, tap Panel_Icon_Reset.

    When using both the keyword search and favorites registration, each function can also be reset individually.

    To reset the keyword search, tap Panel_Icon_Edit to delete the keyword.

    To reset the favorites registration, tap Panel_Icon_BookmarkedAsFavorite for the media you want to reset.

  3. Tap Next.
  4. The Setup Method screen appears. Select whether to use the take-up unit.
  5. Tap Start Setup.
    The cutting carriage moves and detects the width of the media and the positions of the media clamps. This operation is called initialization.
  6. When The media could not be detected automatically.Manually set the printing screen appears, use the following procedure to configure the settings.
    MEMO
    • This message may appear when media with high reflectance is set up.
    • If automatic media detection is not possible and the printing area is set manually when new media is registered, the screen automatically changes to the Printing Area Settings screen in Step (3).
    1. Tap OK.
    2. Enter a new media name and tap OK.
      DA-640_panel_setup_new-media_input-name
    3. Tap Change on the Printing Area Settings screen.
      The Set the right edge of the printing area within the area specified by the pinch rollers. screen appears.
    4. Hold down Panel_Icon_LeftArrow or Panel_Icon_RightArrow to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the left edge of the right pinch roller.

      VG3_MediaWidthSetting_manual_R
    5. Tap OK.
      The Set the left edge of the printing area within the area specified by the pinch rollers. screen appears.
    6. Hold down Panel_Icon_LeftArrow or Panel_Icon_RightArrow to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the right edge of the left pinch roller.

      VG3_MediaWidthSetting_manual_L
    7. Tap OK.
      The set left and right positions are applied to the Printing Area (Width).
    8. Tap OK.
      If the take-up unit is not used, setup is now completed.