3. Select the media.

Procedure
  1. Tap AP-640_Panel_Icon_SETUPSetup.
    The registered media is displayed in a list.
    RegiMedia
  2. Select the media name to use.
    MEMO
    • Tapping IconPen makes it possible to search the registered media by keyword.

      To reset the entered keyword, tap reset.

    • Tapping Favorite Display to the right of the media name will change the symbol to FavoriteDisplay2, and the media will be registered to Favorites.

      Tap the favorites filter (Favorite Display) at the top of the operation panel to turn the filter on (FavoriteDisplay2) and show only favorited media.

      Tap FavoriteDisplay2 to turn the Favorites filter off.

      Tap reset to turn the Favorites filter off (Favorite Display) and reset all keywords.

    • Keyword searching and the Favorites filter can be used at the same time.
  3. Tap Next.
  4. The Setup Method screen appears. Select whether to use the take-up unit.
  5. Tap Start Setup.
    The cutting carriage moves and detects the width of the media and the positions of the media clamps. This operation is called initialization.
  6. When Printing Area (Width) screen appears, use the following procedure to configure the settings.
    MEMO The media selected in step 2 is media whose printing area was set manually when registered as new media. The printing area must be set manually each time, so the Printing Area (Width) screen appears.
    1. Tap Change.
      The Set the right edge of the printing area within the area specified by the pinch rollers. screen appears.
    2. Hold down AP-640_Panel_Icon_LEFT to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the left edge of the right pinch roller.

      VG3_MediaWidthSetting_manual_R

    3. Tap OK.
      The Set the left edge of the printing area within the area specified by the pinch rollers. screen appears.
    4. Hold down AP-640_Panel_Icon_LEFT to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the right edge of the left pinch roller.

      VG3_MediaWidthSetting_manual_L

    5. Tap OK.
      The set left and right positions are applied to the Printing Area (Width).
    6. Tap OK.