Turning the Power Off

WARNING

Remove any loaded media or switch off the sub power when printing is not being performed.

The continued application of heat at a single location may cause the release of toxic gases from the media or pose a fire hazard.

Procedure
  1. When printing is complete, tap AP-640_Panel_Icon_ONOFF on the operation panel.

    The confirmation screen appears.

  2. Tap Yes.
    The sub power switches off automatically.
  3. Raise the loading lever and remove the media.
    If you will leave the sub power on while not using the machine, set it as shown below.
    • Raise the loading lever.

      VG3-LoadingLeverUP

    • Lower the dancer roller toward the rear.
      VG3-640_PushDancerBar