Installing the Object on the Fixing Jig and Performing Printing

Install the object on the fixing jig and perform printing.

This section introduces the subsequent work assuming that writing of the printing file to the RIP has been completed.

Operate the RIP you are using to send data to the output device. For the specific operation procedures, refer to the operation manual of the RIP you are using.

Procedure
  1. Set the object onto the fixing jig that is installed on the output device.
    Be sure to set the necessary quantity in the location for printing.
  2. Operate the RIP and configure various settings for printing on the object.
    For the operation procedures, refer to the manual of the RIP you are using.
  3. When configuration of the settings for printing has been completed, send data to the output device.