Attaching the Small-diameter Adapters

Use the small-diameter adapters when loading an object to be printed on that has a diameter of 10 to 35 mm (0.39 to 1.37 in.).

For information about purchasing small-diameter adapters, contact your authorized dealer.

Procedure
  1. Place the small-diameter adapter as shown in the figure.
    Determine where to set the adapter according to the length of the object to be printed on.
    MEMO Set the small-diameter adapter on the rollers .
    Set_Adapter1
  2. Attach the small-diameter adapter.
    1. Catch the tip of the adapter on the front roller shaft. ()
    2. Push the back of the adapter to fit it into the groove. ()
      MEMO Make sure that the back of the small-diameter adapter is seated properly.
      Set_Adapter2