Attaching the Guide

The guide is available in two types: short and long. Use the type that matches the diameter of the object to be printed on.

  • Short guide: Use this type when loading an object to be printed on with a diameter of 10 to 75 mm (0.4 to 2.95 in.).
  • Long guide: Use this type when loading an object to be printed on with a diameter of 75 to 115 mm (2.96 to 4.52 in.).
Procedure
Attach the short or long guide to the rotary axis unit.
Attach the short or long guide and secure it temporarily with a screw.
Install_Middle
MEMO

Removing the short or long guide

Remove the screw, and then remove the short or long guide.
Remove_Middle2