Filling Text

There are two ways to fill text: [Fill] and [IslandFill]. Select whichever method you desire.

Fill


METAZAStudio_Text_Fill

Text is filled without space.

Island Fill


METAZAStudio_Text_Island_fill

You can specify the interval between adjacent filling lines.
MEMO When performing imprinting with a lot of lines (Island Fill, etc.) on aluminum material or the like, the unevenness of the material surface is increased, and consequently the head cap will wear out faster. Periodically check the state of the head cap to ensure that it is replaced as often as needed.
Procedure
  1. Enter text.
  2. Click icon_METAZAStudio_Property.
    The Properties window appears.
    METAZAStudio_Property
  3. Set the filling and contour of the text.
    1. Click the Fill and Contour tab.
    2. Select the Fill check box.
    3. Select Fill or Island Fill.
      When you select Island Fill, you need to enter the pitch.
      MEMO Pitch is the interval between adjacent filling lines.
    4. Click OK.
      The text is filled.
    METAZAStudio_Text_Fill_01