Setting the Starting Imprinting Height

For material that is easily damaged, set the height at which to start imprinting and detach the head cap before starting imprinting.

If you're performing imprinting while using a head cap, there is no need to perform the work in this section.

Procedure
  1. Press the Power/Movement button.
    The head moves and stops at the position where the tip of the head cap sits on the surface of the material.
    MPX-90S_CenterVise_MoveHead
  2. Loosen the knob.

    Rotate the knob counterclockwise once. Then you can move the stopper.

    MPX-90S_CenterVise_LoosenKnob
  3. Push the stopper down to the lowest position, and then tighten the knob.
    MPX-90S_MoveStopper_woHeadCap
  4. Press the Power/Movement button.

    The head moves to the left rear.

    MPX-90S_MoveHeadCenterV_woHeadCap
  5. While supporting the head, detach the head cap.

    Supporting the head and putting your fingers on the projecting rim of the head cap makes it easier to detach the cap.

    MPX-90S_Remove_HeadCap_wCenterVise