Step 4: Reinstalling the Machine

MEMO

2.5 mm (0.1 in.) and 3.0 mm (0.12 in.) hexagonal wrenches are included. Use the 2.5 mm (0.1 in.) hexagonal wrench for retainers A and B, and the 3.0 mm (0.12 in.) hexagonal wrench for retainers C and D.

Procedure
  1. Once the preparations are complete, move the machine with as little delay as possible.
  2. Immediately reinstall the machine, and then open the front cover and the maintenance cover.
    MEMO

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

    FrontMaintenaceOpen
  3. Using a hexagonal wrench, remove retainers A, B, C, and D.
    SEA_Fixing2
  4. Install retainers A, B, C, and D, which you have removed, at the positions indicated in the figure for storage.

    Use the screw removed in step 3.

    IMPORTANT

    To prevent the loss of the screws that are not being used, store them in the screw holder ().

    ReFixing
  5. Close the front cover and the maintenance cover.
    MEMO

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

    FrontMaintenaceOpen
  6. Turn on the main power switch.
    IMPORTANT

    To prevent the print heads from being damaged, move the machine with as little delay as possible and switch on the main power as soon as possible after moving the machine. To install the machine again, follow the procedure in the Setup Guide.

  7. Press the sub power button.
    The home screen appears.
    MEMO

    If the initial setup or the ink filling is not complete, the language selection screen will appear. Follow the instructions on the screen to carry out the initial setup and ink filling.