Changing the Settings with Batch Media Settings

This section explains how to change media settings as a batch during setup.
Procedure
  1. Tap AP-640_Panel_Icon_MENU.
  2. Tap Media Settings - Batch Media Settings.
    Change the settings for Print Origin, Printing Area, Media Reflective Intensity, Media Suction Force, Output Start Location under Nozzle Drop-out Test, and Printing Movement Range, in that order.
  3. Change the settings for Print Origin and Printing Area.
    Refer to steps 13 through 16 of Determining the Print Surface Height and Printing Position to change the settings.

    When you have finished configuring the settings, tap Save and Proceed.

    Batch1
  4. Change the reflective intensity of the object to be printed on with Media Reflective Intensity.
    Refer to step 2 of Simple Media Reflective Intensity Selection to change the setting.

    When you have finished configuring the settings, tap Save and Proceed.

    MEMO

    If you want to stop after making changes up to this point, tap Save>AP-640_Panel_Icon_HOME.

    Batch2
  5. Change the Media Suction Force.
    Refer to step 5 of Adjusting the Suction Force to change the setting.

    When you have finished configuring the settings, tap Save and Proceed.

    MEMO
    • Media Suction Force is not displayed if a vacuum table is not attached.
    • If you want to stop after making changes up to this point, tap Save>AP-640_Panel_Icon_HOME.
    Batch3
  6. Change the Output Start Location.
    Refer to Step 3 of Step 2: Performing a Nozzle Drop-out Test to perform the test.

    Once you have performed the test, tap Next.

    MEMO

    If you want to stop after making changes up to this point, tap AP-640_Panel_Icon_HOME.

    Batch4
  7. Change the Printing Movement Range.
    Refer to step 3 of Speeding Up Printing for Narrow Objects to change the setting.

    When you have finished configuring the settings, tap Save and Exit.

    Batch5
  8. Tap AP-640_Panel_Icon_HOME to return to the home screen.