Step 4: Installing the Drain Bottle
Procedure
-
Remove the drain pad.
This pad may have soaked up discharged fluid used in the inspection when the printer was shipped. Exercise caution to prevent this fluid from soiling your hands or the floor.
-
Install the drain funnel.
Screw the drain funnel all the way into the hole where the bottom plug was attached.IMPORTANT Use caution to turn the bottle without applying excessive force.
-
Install the drain bottle stand.
Insert the drain bottle stand into the groove on the bottom surface of the printer unit, and then shift the drain bottle stand to the left.
-
Attach the cable to the printer unit, and then secure the drain bottle stand in place.
Fully tighten the two bolts.
-
Install the drain bottle in the bottle stand.
Insert the drain bottle to the back, as far as it will go.IMPORTANT Only remove the drain bottle when you are disposing of the discharged fluid. Unnecessarily removing the drain bottle may lead to the discharged fluid spilling.
