Step 5: Removing the Retainers

IMPORTANT
  • Make sure to remove all the retainers. Any that remain may cause faulty operation or breakdown when the power is switched on.
  • Store the retainers because they are needed again when transporting the machine.
Procedure
  1. Open the front cover.
    Front cover (MG-640)
  2. Peel off the tape fixing in place retainer B and the UV-LED device.
  3. Remove all the retainers indicated by A, B, and C.
    Remove all A, B, and C fixtures
  4. Install the retainer indicated by B at the position indicated in the figure for storage.
    MEMO Install this retainer with the bolt removed in step 3.
    Attaching Fixture B for storage