2. Clean the print heads.

Procedure
  1. Open the left cover.

    LO_CoverLopen

  2. Moisten a new cleaning stick with the cleaning liquid.
    IMPORTANT
    • Be sure to use one of the included cleaning sticks.
    • Do not use a previously used cleaning stick.
    • Do not put a previously used cleaning stick into the cleaning liquid.


  3. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).


    1. Press the wide surface of the cleaning stick against the left side and wipe it off. Then, press the opposite surface (which is clean) against the right side and wipe it off.


    2. Stand the cleaning stick upright and wipe off all sides.


    3. Use the wide surface of the cleaning stick to wipe away any dirt from the area shown in the figure.
      If this area has any ink or cleaning liquid that appears likely to drip, use a dry cloth that is not fluffy to gently wipe away the ink or cleaning liquid.


  4. Close the left cover.
  5. Tap Finish All.
    Cleaning will start. The details of the operation in progress and the (approximate) remaining time of that work are displayed in the status bar at the top of the screen. When the work is finished, the status bar returns to its original display.
  6. Tap AP-640_Panel_Icon_HOME to return to the home screen