1. Perform a printing test for the nozzle mask.
Procedure
-
Set up the object to be printed on.
MEMOLoading the Object, and Setting the Print Surface Height and Print Start Point
The printing test requires an object with a W (width) of 170 mm (6.7 in.) or more and an L (length) of 90 mm (3.55 in.) or more. Set the bottom right of the object to the base point, and then carry out a printing test.
- Tap
.
- Tap .
-
Select Nozzle Mask Test and tap Execute.
Printing of the test pattern starts.
- Check for the nozzle group with dot drop-out or dot displacement by viewing the results of the printing test.The results of the printing test are displayed separately for nozzle groups "1" and "2." The following shows a dot drop-out in nozzle group 1.
MEMOIf the printing-test results are difficult to interpret
Check the results in a bright location, changing your line of vision. They are visible using the reflection of the light.
- If you have opened the front cover, close it.If no dot drop-out or dot displacement occurs, this operation is finished. Tap
to return to the home screen.