Emergency Stop Executed

The front, right, or left cover is open.

For safety, the machine stops if a cover is opened during operation.

Close the open cover.

When the emergency stop button is pressed

Pressing the emergency stop button or activating the emergency stop device (wire) causes an emergency stop on the machine.

Operation cannot be continued. Perform the following operations.

1. Check the safety of the surrounding area.

2. Release the emergency stop button.

3. Press [TS : RESET] to stop the warning beep.

4. Press the sub power button again.

When the emergency stop device (wire) is activated

After confirming that the situation is safe even if this machine starts operating again, operate the recovery device at the bottom of the transporter to recover the operation of the printer unit.

The flushing cover inside the right cover is open.

If the machine is operated with the flushing cover open, the machine will stop to prevent collisions.

Close the flushing cover.