1. Replace the wipers.

Procedure
  1. Press [ENTER] when the following screen appears.


  2. Remove the object to be printed on.
  3. Press [MENU].
  4. Press [▼] several times to display the screen shown below.


  5. Press [▶] once, and then press [▼] several times to display the screen shown below.


  6. Press [▶], then [▼] to display the screen shown below.


  7. Press [ENTER].
    After "NOW PROCESSING" is displayed and the operation for wiper replacement is performed, the screen shown below appears.


    MEMO: Refresh the heads if the following message is displayed.


  8. Open the front cover.
    Preparation is complete once the following screen is displayed.


  9. Open the maintenance cover.

    Remove the screw on the top of the maintenance cover, tilt the maintenance cover forward slightly, and then pull out the maintenance cover in the direction indicated by the arrow.



  10. Touch the location shown in the figure to discharge any static electricity.


  11. Replace the wipers.
    1. Detach both of the old wipers.
      Using the tweezers, unhook the wipers, and then pull them up. Using the tweezers to press on the hook in the hole on the wiper makes it easier to remove the wiper.
    2. Attach both of the new wipers.
      Insert the wipers with the orientation shown in the figure.
      Be sure to attach the wipers to the hooks. Failure to do so may result in dot drop-out or other problems.
      MEMO:

      Replace the two wipers at the same time.