Using Transparent Media

You can set up transparent media by disabling detection of the leading and trailing edges of the media.

Normally, detecting the leading and trailing edges of the media enables you to verify the presence of the media, and the media is then ready for setup. However, since transparent media cannot be detected, setup will not be possible.

  1. Press MENU.
  2. Press ▼ several times to display the screen shown below.


  3. Press ▶ to display the screen shown below.


  4. Press ▶ to display the screen shown below.


  5. Press ▲ or ▼ to select DISABLE.
  6. Press ENTER to confirm your entry.
  7. Press MENU to go back to the original screen.
    MEMO:

    • Default setting: ENABLE

    • When set to DISABLE, printing operation does not stop when the media runs out. If media runs out while printing is in progress, immediately press PAUSE to stop printing. Otherwise, there is a chance that the platen or other parts may become soiled by ink or that ink may get inside and damage the machine.