Setting Perforated Cutting Conditions on the Machine

Set up perforated cutting conditions on the operation panel of the machine. In this example, "HALF LEN.", "HALF FORCE", and"CUT LEN." will be set.


GS2_PerforatedLine-0
  • : "CUT LEN."
    • Length of the part cut out from the material
  • : "HALF LEN."
    • Length of the part not cut out from the material with suppressed blade force

Adjust "HALF FORCE" according to the type of material.

"CUT LEN."＞"HALF LEN." "CUT LEN."＝"HALF LEN." "CUT LEN."＜"HALF LEN."
GS2_PerforatedLine-1 GS2_PerforatedLine-equal GS2_PerforatedLine-2
Cut Length: 20 mm (0.8 in.) Cut Length: 20 mm (0.8 in.) Cut Length: 1 mm (0.04 in.)
Half-cut Length: 1 mm (0.04 in.) Half-cut Length: 20 mm (0.8 in.) Half-cut Length: 20 mm (0.8 in.)
Procedure
  1. Press [MENU] several times to display the following screen.
    MENU_CONDITION
    MEMO
    When the material is loaded, press [MENU] several times to display the following screen.
    MENU_UNSETUP
  2. Press [▼] several times to display the following screen.
    MENU_OTHERS
  3. Press [▶].
  4. Press [▲][▼] to display the following screen.
    MENU_PERFORATE_OFF
  5. Press [▶].
  6. Press [▲] or [▼] to select "ON".
  7. Press [ENTER] to select the setting.
  8. Press [▶] twice to display the screen shown below.

    Set the half-cut length.


    MENU_PERFORATE_HALF-LEN_Select
    1. Press [▶].
    2. Press [▲] or [▼] to select a value.
      MENU_PERFORATE_HALF-LEN_0.5-0.5
    3. Press [ENTER] to select the setting.
  9. Press [▼] to display the following screen.

    Set the half-cut force.


    MENU_PERFORATE_HALF-FORCE_Select
    1. Press [▶].
    2. Press [▲] or [▼] to select a value.
      MENU_PERFORATE_HALF-FORCE_5-5
    3. Press [ENTER] to select the setting.
  10. Press [▼] to display the following screen.

    Set the cut length.


    MENU_PERFORATE_CUT-LEN_Select
    1. Press [▶].
    2. Press [▲] or [▼] to select a value.
      MENU_PERFORATE_CUT-LEN_15.5-15.5
    3. Press [ENTER] to select the setting.
  11. Press [MENU] to return to the original screen.