Jump to main content
User's Manual
User's Manual
  • Basic Handling Methods
  • Output Method
  • Optimizing Quality and Efficiency
  • Maintenance
  • Troubleshooting Methods
  • Appendix
INDEX
INDEX
  1. Home
  2. Troubleshooting Methods
  3. Machine Problems
  4. Connecting More Than One Machine to One Computer (Mac)
  5. Connecting via Ethernet (Automatically Set IP Address)
  6. Step 3: Registering the Machine in VersaWorks
  • Basic Handling Methods
  • Output Method
  • Optimizing Quality and Efficiency
  • Maintenance
  • Troubleshooting Methods
    • Cutting Problems
    • Machine Problems
      • The Machine Doesn't Run
      • The Power Cannot Be Switched Off
      • Unable to Set Up Cut Material with "PIECE"
      • Connecting More Than One Machine to One Computer (Windows)
      • Connecting More Than One Machine to One Computer (Mac)
        • Connecting via Ethernet (Manually Set IP Address)
        • Connecting via Ethernet (Automatically Set IP Address)
          • Step 1: Connect LAN Cables
          • Step 2: Checking the Settings of the Machine to Connect
          • Step 3: Registering the Machine in VersaWorks
    • Software Problems
    • Messages on the Operation Panel
  • Appendix

Step 3: Registering the Machine in VersaWorks

If you are using Windows, refer to VersaWorks Installation and License Authentication in GS2-24 Installation and Initial Settings and register the machine in VersaWorks.

If you are using a Mac, refer to VersaWorks Installation and License Authentication in GS2-24 Installation and Initial Settings and register the machine in VersaWorks.

  • Basic Handling Methods
  • Output Method
  • Optimizing Quality and Efficiency
  • Maintenance
  • Troubleshooting Methods
    • Cutting Problems
    • Machine Problems
      • The Machine Doesn't Run
      • The Power Cannot Be Switched Off
      • Unable to Set Up Cut Material with "PIECE"
      • Connecting More Than One Machine to One Computer (Windows)
      • Connecting More Than One Machine to One Computer (Mac)
        • Connecting via Ethernet (Manually Set IP Address)
        • Connecting via Ethernet (Automatically Set IP Address)
          • Step 1: Connect LAN Cables
          • Step 2: Checking the Settings of the Machine to Connect
          • Step 3: Registering the Machine in VersaWorks
    • Software Problems
    • Messages on the Operation Panel
  • Appendix

Feedback

1 2 3 4 5
NO YES

Feedback

Thank you

GS2/R4-260422

Copyright © 2022-2026 Roland DG Corporation  
https://www.rolanddg.com/

User's Manual