Step 5: Setting the Cutting Conditions

Procedure
  1. Check that the material has been properly loaded and set up.
    Setting Up Material
  2. If Roland DG Connect Hub and VersaWorks are not running, start them.
  3. Open the created Print & Cut data.
    To access Designer again, click RDGCD_Icon_Menubar_EditSVG on the right of the corresponding data under Open Recent.
  4. Display the cutting layer of the print data.
    1. On the function toolbar, click RDGCD_Icon_Layoutbar_Layers Layers.
    2. Click LayerOFF for the cutting layer to display it.