1. Save the cutting conditions

Up to four sets of cutting conditions, which include blade force, cutting speed, and offset, can be saved from the panel of this machine.
Procedure
  1. Press [TOOL SELECT].
    If material is loaded, press ON/OFF LINE to switch to offline mode.
    The number of the currently applied preset is displayed. Normally 1 is displayed if no presets are registered.
    MEMO Preset names are fixed with numbers 1 through 4, and cannot be changed.
    MENU_TOOL_Set_1

  2. Press [▼] to select your desired preset number.

    Register cutting conditions to the number selected here.

  3. Press [ENTER].
  4. Edit the cutting conditions: [SPEED], [FORCE], and [OFFSET].
    The cutting conditions are saved to the selected preset number.Adjusting the Cutting Conditions