Cutting Remaining Unused Material

Set the origin to be used as the cutting start position to anywhere in the output area. You can cut without setting the origin, but setting the output area allows you to use material without being wasteful, and also to cut targeted locations.

Procedure
  1. Check that the material has been properly loaded and set up.
  2. Press [◀], [▶], [▲] or [▼] to move the cutting carriage to the location you want to set as the origin.
    MEMO

    The origin point can be set in either online mode or offline mode.

  3. Press [ENTER].

    The origin point (cutting start location) is set.