| When installing the machine |
Spindle Run-in (Warm-up)
Correcting the Milling Position
|
| When replacing the spindle unit |
| When the machine has not been used for a prolonged period |
Spindle Run-in (Warm-up) |
| Before milling on days when the ambient temperature is low |
| When moving the machine to a different installation site |
Correcting the Milling Position |
| When the milling position is misaligned |
| When symptoms such as a hole in the Z direction occur |
| Once a month |
Retightening the Collet |
| When the working time of the spindle exceeds 200 hours |
| When water or dust accumulates on the regulator |
Cleaning the Bowl |
