Step 2: Attaching the Adapter to the Machine

Procedure
  1. Turn on the machine.
    The machine starts the initial operations. When the status light stops flashing and remains steadily lit, the initial operations are complete.
  2. When the initial operation is finished, open the front cover.

    Pull until a click is heard.

    DWX-53DC_AdapterAreaCover_Open
  3. With its adapter ID facing you, insert the adapter into the clamp.

    Gently push in the adapter all the way along the groove in the clamp.

    Inserting it with too much force will make the adapter strike the inside of the machine, possibly leading to injury and workpiece damage.

    DWX-53DC_Adapter_Insert_normal
  4. Secure the adapter.

    As shown in the figure, close the fixing knobs (in two locations) in the directions of the arrows while pressing in on the adapter to secure the adapter.

    DWX-53D_clamp_close_normal
  5. Lightly tug on the adapter to check that it does not come loose.
  6. Close the front cover.

    Gently pull up on the front cover and then lower it until a click is heard.

    DWX-53DC_Cover_Close