1. Installing the Detection Pin

Procedure
  1. Remove any debris that is present around the clamp.
  2. Use the included cloth for maintenance and care to wipe the clamp (), correction protrusion (), and milling bur sensor () clean.
    If any dirt is present in these locations, it may not be possible to perform the correction properly.
    IMPORTANT Also wipe the bottom of the clamp () clean.
    DWX-53DC_AutoCorrection_01
  3. Wipe the detection pin () and the top () and bottom () of the automatic correction jig clean.

    Clean the gray parts in the following figure. If any dirt is present in these locations, it may not be possible to perform the correction properly.

    IMPORTANT Also wipe the bottom and the shaft of the automatic correction jig clean.
    DWX-53DC_AutoCorrection_02
  4. Load the detection pin in the ATC magazine's number 15 position.

    Insert the detection pin firmly into the ATC magazine.

    DWX-53DC_AutoCorrection_03