4. Removing the Detection Pin and the Automatic Correction Jig

Once correction is complete, remove the detection pin and the automatic correction jig, clean them, and then store them.
Procedure
  1. Open the tool area cover and the adapter area cover.
  2. Remove the detection pin.
    DWX-53DC_DetectorPin_Remove
  3. Remove the automatic correction jig.

    Pull the jig out slowly. Exercise caution to avoid striking the inside of the adapter area with your hands or other body parts when pulling out this part.

    DWX-53DC_Adapter_Eject
  4. Store the detection pin and the automatic correction jig in the bottom storage.
    MEMO

    Store the automatic correction jig () with the surface shown in the following figure facing up.

    DWX-53DC_AutoCorrectionJIG_PIN_Cleaning