103D-0000Milling data error. The milling bur cannot reach the milling position.

Situation/Error Cause
  • The milling bur is too short to reach the milling position.
  • The angle of the A axis is too large and the milling bur does not reach the milling position in the Z direction.
Procedure
  1. Hold down the operation button on the built-in panel.
    This will clear the error.
  2. Review the milling bur length and the position of the milling bur holder.
    Setting the Milling Bur
  3. Review the CAM settings and decrease the angle of the A axis.