Mounting the Workpiece

Procedure
  1. Open the front cover.

    Hold the parts shown in the figure with both hands and open the cover.

    DWX-43W_main_10
  2. Insert the pin portion of the workpiece into the hole on the rotary axis.

    Align the notch on the root of the workpiece's pin with the protrusion on the rotary axis so as to eliminate the gap between the attaching surfaces.

    You can install a maximum of three workpieces.

    DWX-43W_work_03
  3. Use a mounting screw to secure the workpiece in place.

    Tighten the mounting screw with a hexagonal screwdriver.

    DWX-43W_work_04
  4. Mount the workpiece on the holder.

    Align the notch on the root of the workpiece's pin with the protrusion on the holder so as to eliminate the gap between the attaching surfaces.

    You can install a maximum of three workpieces.

    DWX-43W_multi_pin_clamp_01
  5. Use a mounting screw to secure the workpiece mounted on the holder.

    Tighten the mounting screw with a hexagonal screwdriver.

    DWX-43W_multi_pin_clamp_02
  6. Attach the holder to the rotary axis.
    1. Insert the positioning pins on the rotary axis into the holes on the holder.
      DWX-43W_multi_pin_clamp_03
    2. Check that the holder does not lift up off of the rotary axis.
      IMPORTANT

      Correct milling will not be possible with the holder lifted up.

      Also, tightening the bolts with the holder lifted up may damage the multi-pin clamp.

      DWX-43W_multi_pin_clamp_05
  7. Secure the holder with two bolts.

    Tighten the bolts with a hexagonal screwdriver.

    DWX-43W_multi_pin_clamp_04
  8. Close the front cover.

Before starting milling, check that the milling bur to be used for milling is set and that registration has been completed.