Setting the Oven Temperature
-
Basically, use the software RIP (color profile) settings for temperature. Even if you use the settings of the software RIP, if you need to adjust the temperature, such as when the intended foaming condition is not obtained, change the temperature in the machine settings.
- The temperature must not be too high or too low. Set a temperature that is reasonable for the media. If the temperature is too low, foaming will not proceed far enough, resulting in unclear height differences. Conversely, if the temperature is too high, foaming will proceed too far, resulting in not only unclear height differences (the same as when the temperature is too low) but also in a rough surface on the media.
Procedure
- Set up the media.
- Tap the following location on the home screen.The Heater Temperature window appears.
-
Tap
or
to set the Oven temperature.
When media foaming is insufficient, increase the temperature. When media foaming is excessive, decrease the temperature.MEMO- Default setting: 340°C (644°F)
- Tap Save to confirm your entry.
-
Tap
.
MEMO-
You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software RIP's setting is used.
The home screen appears. -