Adjusting the Ink-drying Temperature and the Media-heating Temperature

Set the heater temperature used to dry the ink and adjust the oven temperature used to heat the media and cause it to foam. You can adjust the temperature settings to match the type of media and the printing speed.


AP-640_MediaHeatingSystem

Print Heater This is used to dry the CMYK ink after printing, preventing the colors from smudging even when structural ink is printed on top of the CMYK ink.
Oven This is used to heat foaming media.
WARNING

High Temperature

The inside and back of the oven, media immediately after it is heated by the oven, exhaust from the oven, and the hose close to the exhaust port all become hot. Exercise caution to avoid burns.

WARNING

Remove any loaded media or switch off the sub power when printing is not being performed.

The continued application of heat at a single location may cause the release of toxic gases from the media or pose a fire hazard.

WARNING

Never use media that cannot withstand heat.

Doing so may result in fire or the release of toxic gases or may degrade the media.

WARNING

Never use the oven for any purpose for which it is not intended, such as heating something other than media.

Doing so may cause overheating, resulting in fire or accident.