Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)

This adjusts the landing position of the ink discharged from the print heads. The landing position varies according to the print head height and the thickness of the media, so we recommend that you make corrections to match the media you are using.

First, print a test pattern, and then determine and enter the correction value. After entering the correction value, print a test pattern again and check the correction results.

This adjustment must be performed in the following cases.

  • When using this machine for the first time

  • When changing the media to use

MEMO

Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.

https://youtu.be/VzQH-mLgvm0
VzQH-mLgvm0

The BN2-20/20A is shown in this video, but the work and operation procedures are the same for this machine.

Procedure
  1. Set up the media.
  2. Close the front cover.
  3. Click AP-640_Panel_Icon_MENU.
  4. Click Execute under List of Media Settings - Media Gap Adjustment - Detailed Media Gap Adjustment (Manual).
  5. Click Execute.
    Printing of the test pattern starts.
  6. Check the printed test pattern, and then enter the No. 1: H1 and H2 and the No. 2: H1 and H2 correction values.
    Select the value that gives the least misalignment between the two lines. In the case of the following figure, select "+5" for H1 and "+4" for H2. When you cannot choose between two sequential numbers, select a value that is between them (you can set correction values in units of "0.5").

    VG2_MEDIAGAP_TESTPRINT_DETAIL

    MEMO
    • If the test pattern is difficult to see, click UtilityMoveUP or UtilityMoveDOWN next to Move to move the media to a position where it is easier to see.
    • If you want to hold the media to check the test pattern, you can also use the sheet cutting function to separate the media.
  7. Click Apply.
    The entered correction values are saved.
  8. To check the adjustment results, click Output again.
    The test pattern is printed again.
  9. Check the test pattern to see whether the correction was successful.
    For all the correction values, check that the misalignment is minimized for the two vertical lines indicated by "" (that is, the current correction value). If the misalignment is smaller for another set of vertical lines, set the correction value again.
  10. When you have successfully performed the adjustment, click OK to return to the original screen.