Step 5: Configuring FlexiDESIGNER VersaSTUDIO Edition Settings

Procedure
  1. Make sure the power to the printer is switched on.
  2. Click Open next to VersaWorks in the Roland DG Connect Hub home screen.
  3. Set the printer to connect.

    The first time you register printers in VersaWorks, the connectable printers are automatically searched for and registered.

    However, this automatic registration does not occur if no printers are detected or if five or more printers are detected. In these situations, register printers manually.

    MEMO If you are already using VersaWorks, printers are registered automatically, and the machine information is displayed in the top menu.
    VW_TOP
    When at least one printer is detected:
    1. When the window of the detected printer appears, click OK.
    2. When the message Do you want to install the virtual printer driver? is displayed, click Yes.
      This message does not indicate the printer driver to use in communication. It indicates the virtual printer driver to use when printing directly from the application.
    3. When the User Account Control window appears, click Yes(or Allow).
    4. When the Add Printer Wizard window appears, click Next.
      Registration is complete once the machine information is displayed in the top menu.
    When no printers are detected or five or more printers are detected:
    1. Enter the IP address and click Verify.
      Items such as the Model Name and Firmware Version are displayed.
      MEMO If the printer cannot be found, check the LAN cable connection status.
    2. Set the Nickname.
      If you do not set a nickname, the model name is displayed.
    3. Click Apply.
      VW_PrinterSetting
    4. When the message Do you want to install the virtual printer driver? is displayed, click Yes.
      This message does not indicate the printer driver to use in communication. It indicates the virtual printer driver to use when printing directly from the application.
    5. When the User Account Control window appears, click Yes(or Allow).
    6. When the Add Printer Wizard window appears, click Next.
      The information of the connected printer appears in the Printer List.
    7. Click OK.
      Registration is complete once the machine information is displayed in the top menu.
This completes setup.