Install the software from Roland DG Connect Hub.

Use Roland DG Connect Hub to install the related software. After the software is installed, you can perform operations such as starting and updating the software from Roland DG Connect Hub.

Procedure
  1. Start Roland DG Connect Hub.
    • Windows

      Click the Roland DG Connect Hub icon in the notification area.

    • Mac

      Click the Roland DG Connect Hub icon on the Dock.

    MEMO

    When using Windows, if the Start Roland DG Connect Hub checkbox was cleared in the Roland DG Connect Hub setup wizard, start from Start after setup is completed.

  2. Refer to the Master Initial Setting Guide to perform the following operations.
    https:// downloadcenter.rolanddg.com/contents/software_parts/connect_info_en.html
    1. Create a Roland DG Connect ID.

      If you already have an ID, proceed to the next step.

    2. Configure the Connect Hub settings.
  3. Turn on the main power switch.
    BN2_MainPower
  4. In the home screen, select the machine to use.
    IMPORTANT

    If the printer to register cannot be detected, refer to the Roland DG Connect Help.

    https://support.rolanddg.co.jp/hc/ja/sections/7536518110105-Roland-DG-Connect

  5. Click the software's icon.

    A sidebar appears on the right side of the window.

    VW_INS
  6. Click Install.
    The software installation starts.

    To install multiple pieces of required software, click the icon for each piece of software in the same way.

    After installing the software, click its icon to start it.