List of Media Settings

MEMO In Utility, the window that lists the setting values of objects is called the List of Media Settings.

This window displays the setting information of the object that has been set up. This window is not displayed if the object has not been set up.

You can check and change^*1 the setting values when registering the objects. To the right of Print Origin is an item to be set when changing the Origin Relative. It is not a setting for this media.

For more information, refer to Object (Media) Registration Items.

Printing Zone

Flat Table Height

The height direction position to be printed is displayed.

Print Origin

The point that will serve as the base for printing position is displayed as the distance from the lower right reference point (S: 0 mm [0 in.], F: 0 mm [0 in.]) on the flat table.

Printing Area

The area to print that uses the print origin as the base is displayed in the distance (mm) in the W:S direction and then in the distance (mm) in the L:F direction.

Flat Table Lowering Amount

The setting values for how far down from the standard flat table position to print are displayed.

Object Type

Transparent or Opaque is displayed.

Printing Movement Range

The operation width of the print-head carriage when printing is displayed as either Output Data Width, Media Width, or Full Width.

MEMO Media Width will be the width set for the printing area.