Preferences

Clearance Settings

Sets the action to be taken when a height error occurs during printing. Select from Stop or Readjust.

If Readjust was selected, set the amount to lower the flat table in Maximum Value (Threshold).

Deodorizer Settings

Changes the deodorizer mode. Select from Strong, Medium, Weak, or Off.

You can also set the suction power for each mode.

Flat Table Height/Object (Media) Thickness

Changes the height direction reference. Select from Height (Lowered Flat Table Treated as Height of 0) or Thickness (Raised Flat Table Treated as Thickness of 0).

Operation before Printing

Set whether to check the height of the object after the object is set up and before printing starts.

Ink Circulation Interval

Sets the frequency of white ink circulation to prevent uneven color issues. Select from 30 to 360 minutes in increments of 30 minutes.

Sleep Time

Sets the time until sleep mode (the state in which the power-saving features operate) activates. Select from 15 to 120 minutes in increments of 15 minutes.

Date and Time

Changes the date and time printed on the nozzle drop-out test.

Alignment Marker Printing

Prints alignment markers over the flat table. Set up tape for alignment markers or similar to enable Execute.

Rotary Unit Attachment/Removal

This is used when attaching/removing the rotary axis unit.

Initialize Settings

Clicking Execute returns List of Media Settings, Preferences, and Network to their factory default values. However, Position Adjustment will not be initialized.

Position Adjustment

• Adjust Manual Cleaning Tool Position

  Adjusts the position when the manual cleaning tool is changed.

  Execute is not enabled when the object is set up. Cancel the setup, and then remove the object.

• Adjust Pointer Position

  Adjusts the misalignment between the printing area and the pointer position.

  Set up media for pointer position adjustment to enable Execute.