Adjusting the Pointer Position

Adjust the pointer's printing position if there is misalignment between the printing area set by the pointer and the actual printing.
IMPORTANT You can use the pointer to adjust the base position while keeping a close eye on it by working with the front cover open.

However, clicking OK with these settings configured may cause the print-head carriage or flat table to start moving. Therefore, when the front cover is open, be careful not to touch any moving parts as you work.

Procedure
  1. Set up the nozzle drop-out test paper.
    Registering and Setting Up the Nozzle Drop-out Test Paper
  2. On the Utility home screen, click BN2_Utility_Icon_MENU.
  3. Click Preferences.
  4. Click Execute under Position Adjustment - Adjust Pointer Position.
  5. When the This prints the position adjustment pattern. window appears, click OK.
    After printing a pattern for position adjustment the pointer illuminates near the printed pattern.
    BD-8_AdjustPointerPosition
  6. Adjust the position of the pointer.
    1. Click AP-640_Panel_Icon_UP, AP-640_Panel_Icon_DOWN, AP-640_Panel_Icon_LEFT, and AP-640_Panel_Icon_RIGHT to move the pointer inside the inner square.
      BD-8_AdjustPointerPosition2
    2. Click OK.
      The corrected pointer position is applied and the sub power is turned off.