Setting the Base Position of the Manual Cleaning Tool

When the manual cleaning tool is replaced due to damage or deformation, set the base position.
IMPORTANT You can use the pointer to adjust the base position while keeping a close eye on it by working with the front cover open.

However, clicking OK with these settings configured may cause the print-head carriage or flat table to start moving. Therefore, when the front cover is open, be careful not to touch any moving parts as you work.

Procedure
  1. Remove the object, and then cancel the setup.
  2. On the Utility home screen, click BN2_Utility_Icon_MENU.
  3. Click Preferences.
  4. Click Execute under Adjust Manual Cleaning Tool Position.
    If in a setup state, Execute will be unavailable.
  5. Follow the instructions on the Utility window to adjust the position of the manual cleaning tool.
    1. When the This starts manual cleaning tool position adjustment. window appears, click OK.
    2. Open the front cover.
    3. Attach a new manual cleaning tool.
    4. Close the front cover.
    5. Click OK.
      The print-head carriage and flat table move, and then the pointer illuminates near the base position of the manual cleaning tool.
    6. Click AP-640_Panel_Icon_UP, AP-640_Panel_Icon_DOWN, AP-640_Panel_Icon_LEFT, or AP-640_Panel_Icon_RIGHT to align the pointer to the manual cleaning tool reference position.
      BD-8_AdjustMCTool
    7. Click OK.
      The print-head carriage and flat table return to their original positions.
    8. When Remove the manual cleaning tool. is displayed, open the front cover and remove the manual cleaning tool.
    9. Click OK.
    10. Close the front cover.
  6. Click Close to return to the original screen.