Considering a Jig

As the distance between the object and the print heads increases, the likelihood of ink mist^*1 increases. Therefore, a jig might be required according to the size and shape of the object to be printed on. Prepare a jig if one of the following conditions is met.

If it is difficult to obtain a jig, cover the sides of the object with masking tape or similar to avoid adhesion of ink mist.

When with just the object, no margins can be secured in the areas 40 mm (1.57 in.) to both the front/back and left/right of the portion of the data to be printed

	Print heads		Data area
	Object to be printed on		Margin: 40 mm (1.57 in.) or more
	Jig		Less than 2 mm (78.7 mil) in height difference from the actual print surface

The variation in height of the surface of the object is 2 mm (0.08 in.) or more

	Print heads		Data area
	Object to be printed on		Margin: 40 mm (1.57 in.) or more
	Jig		Less than 2 mm (78.7 mil) in height difference from the actual print surface