1. B: Determine the positions of the media (transparent media, etc.).

Use the following procedure to determine the positions of the media when using transparent media and media with high reflectance, whose edges cannot be detected.
Procedure
  1. Tap AP-640_Panel_Icon_ONOFF on the operation panel.
    The sub power is switched on.
  2. Set the Skewing Correction Support at Setup.
    1. Tap AP-640_Panel_Icon_MENU.
    2. Preferences - Skewing Correction Support at Setup
    3. Select Disable and tap Save.
    4. Tap AP-640_Panel_Icon_HOME to go back to the original screen.
  3. Open the front cover.
  4. Move the media clamps to the outside of the grit rollers on the left and right edges respectively.

    AP-640_RemoveMediaclamp

  5. (Move to the rear of the printer.) Release the locking mechanisms of the media holders, and then draw them to the left and right ends respectively.

    AP-640_UnsetMediaHolder

  6. Pass the leading edge of the media between the pinch rollers (A) and the grit rollers (B).

    VG3-640_PullMediatoFront_Cutmedia

  7. Lower the loading lever (rear).
    The media is held in place.
    VG3-Rear-LoadingLever-Down

  8. (Move to the front of the printer.) Gently hold down the media and raise the loading lever (front).
    The media is released.
    VG3-Rear-LoadingLever-UP

  9. Insert the leading edge of the media into the dryer.
  10. Make sure the right edge of the media is in line with the guide line (A).

    AP-640_CheckMediaGuideline

  11. Lower the loading lever (front).

    The media is held in place.


    AP-640_LeverDOWN

  12. Line up the edges of the media with the centers of the holes of the left and right media clamps.

    AP-640_SetMediaclamp

    IMPORTANT

    Be sure to use the media clamps when you load media.

    If you attach the media clamps directly before printing after the media setup is complete, the machine may print on the media clamps.

  13. Close the front cover.