3. Attach the media holders.

Procedure
  1. Position the motorized media holder as shown in the figure.
    Be sure to pass this holder behind the stand.

    ER-642_attach_media-holder1

  2. Place the two shafts on the arms.

    ER-642_attach_media-holder2

  3. Pass the shaft through the motorized media holder.
    1. Pass the front shaft through the motorized media holder.
    2. Catch the motorized media holder on the rear shaft.


  4. In the same manner, pass the shaft through the left media holder on the left side of the printer as seen from its front.


  5. Lower the levers (A) to secure the left and right media holders.
    Leave approximately 100 mm (3.94 in.) of space from the edges.


  6. Attach the shaft clamps, securing the shafts with two bolts.
    IMPORTANT Ensure the media holders do not get caught in the shaft clamps.