Editing Cutting Lines

Procedure
  1. Select the job to which to add a cutting line from the job list.
    IMPORTANT: Cutting lines can only be added to PDF-format jobs.
  2. Right-click the selected job, and then click Job Assistant.
    The Job Assistant window appears.
  3. Click .
  4. Click the cutting line to be edited.
    You can select multiple shapes by holding down the Shift key while clicking.
  5. Select the editing method Replace with Cutting Line.
  6. Change the cutting line conditions.
    IMPORTANT:

    If you do not want to change the distance between the printing data and the cutting line with the original cutting line, set Offset to 0.

    Setting Offset to anything other than 0 will result in it being set as the offset amount from the selected cutting line.

    Type of Cut  


    Cut    		 Cuts solid lines over the cutting lines that were created.


    Perforated Cut    		 Cuts perforated (broken) lines over the cutting lines that were created.

    Create Cutting Line / Replace with Cutting Line  
    Type of Contour
    Outline: Creates a cutting line based on the selected image outline. This will ignore any clipping mask.

    Clipped Outline: Creates a cutting line based on the outline of the unmasked portion if the selected image had a clipping mask. If the selected image does not have a clipping mask, it creates a cutting line in the same manner as Outline.

    Bounding Box: Creates a rectangular cutting line around the selected image.
    Cut Interior

    Cut Interior: If there are outlines on the inside of the selected image (as in the figure to the lower left), or you have selected multiple images and outlines can be made on the inside of adjacent images (as in the figure to lower right), a cutting line will be created on the inside.

    Do Not Cut Interior: Even if there are outlines on the inside of the selected image (as in the figure to the lower left), or you have selected multiple images and outlines can be made on the inside of adjacent images (as in the figure to lower right), a cutting line will not be created on the inside.
    Corner Shape
    Miter: Creates a cutting line that maintains the corner shape. Note however that if Miter Limit is on, the cutting line will be chamfered depending on the angle.

    Round: Creates a cutting line that rounds the corners.

    Bevel: Creates a cutting line that chamfers the corners.
    Miter Limit

    * This setting is only enabled when Miter is selected in Corner Shape.

    OFF: Creates a cutting line that maintains the corner regardless of the angle.

    ON: Chamfers the corners according to the Angle settings.
    Angle

    * This setting is only enabled when Miter Limit is on.

    Use the slider to set the Angle to be chamfered. For example, the more you set the angle to the Large direction, the wider will be the angle at which chamfering is performed.
    Offset Sets the distance from the outline of the selected shape at which to create the cutting line.
  7. Click Replace.
    The cutting line will be changed according to set conditions.
    MEMO: To merge multiple cutting lines that were already created, perform one of the following procedures:
    1. Select the editing method Merge Multiple Cutting Lines on the Job Assistant screen.
    2. Click the cutting lines to be merged.
      You can select multiple shapes by holding down the Shift key while clicking.
    3. Click Merge.
      The selected cutting lines will become a joined cutting line.

  8. Click OK.
  9. In the confirmation window, click Yes.
    The Job Assistant window closes. It will be added to the job list as a new job.